Remote Contol Buttons For Lcd Tv Functions - Philips 32PF5320/98 User Manual

Remote Control Buttons for LCD TV Functions
1) (STANDBY)
To set the TV to standby mode. To switch the TV
set on again, press P –/+ or 0 to 9 buttons or
button.
2) Pixel +
versions)
Switches the Pixel + demonstration mode on or off.
3)
® I Ò ‡ π † I º
Peripheral device buttons
(Refer to "Mode selector" on page 5)
4) Q Surround mode
To activate / deactivate the surround sound effect.
In stereo, this gives the impression that the speakers
are further apart. For models equipped with Virtual
Dolby Surround*, you can experience Dolby
Surround Pro Logic sound effects.
5) AV
To display Source List to select TV or peripheral
equipment connected to TV, AV, REAR/SVHS,
CVI-1(SD/HD), CVI-2(SD/HD), HDMI, PC-VGA, or
PC-D (Quick Use Guide).
6) h Active control
Optimizes the picture quality depending on the
quality of the incoming signal and the ambient light
conditions.
7) MENU
To call up or exit the TV menus.
8) Cursor
These 4 buttons are used to navigate around the
menus ( ÎïÍÆ ).
9) Volume
To adjust the sound level.
10) Smart picture and sound
Used to access a series of predefined picture and
sound settings.
11) Screen information
To display/remove the programme number, the time,
the sound mode and the time remaining on the timer.
Hold down for 5 seconds to permanently display the
programme number on the screen.
*Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbols are
trademarks of Dolby Laboratories.
4
(only available on certain models/
1)
AV
2)
3)
4)
5)
6)
7)
8)
9)
10)
11)