Table of Contents
Advertisement
6 Quick Installation
When you switch on the TV set for the first
time, a menu is displayed on screen. This
menu prompts you to select the country of
your choice.
Country
B
CH
D
DK
E
F
FI
GB
Note: If the above menu is not displayed,
proceed to do the installation of channels by
the Auto Store method (see page 9). If above
menu is displayed, proceed to the following
steps:
Press the Î ï keys on the remote control
to select your country. If your
country does not appear in the list,
select ". . . " . Refer to the "Reference
table of countries" on page 33.
Press the Æ /
1.
language mode.
Select your language by using the Î ï
2.
keys.
Language
English
Dansk
Nederlands
Suomi
Français
Deutsch
Eλληνικα
Italiano
Press the Æ /
3.
EN-8
Press OK
to continue
key to select the
Press OK
to continue
key to start search.
The search starts automatically. All the
available TV programmes will be stored.
This operation takes a few minutes.
The display shows the progress of the
search and the number of programmes
found.
Important : To exit or interrupt the
search before it is completed, press the
menu key. If you interrupt search during
auto store, not all channels will be stored.
To store all channels, you must perform a
complete auto store search again.
ATS (Automatic Tuning System)
If the transmitter or cable network sends
the automatic sort signal, the programmes
are numbered correctly. In this case, the
installation is complete.
If the transmitter or cable network does
not send the automatic sort signal, the
programmes are not numbered correctly.
You can use the Sort menu to number the
programmes.
ACI (Automatic Channel Installa-
tion)
If a cable system or a TV channel which
broadcasts ACI is detected, a programme
list appears. Without ACI broadcast, the
channels are numbered according to your
language and country selection. You can use
the Sort menu to renumber the channels.
Hide quick links:
Advertisement
Table of Contents
