From front element of lens to infinity Mount system M67 or NA Bayonet Package Contents: • 83201 Wet Wide Lens 1 (WWL-1) • 25024 Neoprene cover • 83221 Rear lens cap for WWL-1 • 83211 M67 Mounting Ring for WWL-1 •...
Page 2
Changing the Mounting Ring: The WWL-1 comes with two mounting rings with NA Bayonet mount pre-installed. M67 mount NA Bayonet mount Follow below instruction to change the mounting ring: 1. Remove the eight screws from the back of the lens.
Page 3
3. Observe the 4 small sockets in the bayonet ring. Place the bayonet ring onto the WWL and rotate the ring until it seats on the WWL. 4. Secure the mounting ring by tightening the eight screws. Do not over-tighten, the screws only need to be snug.
Page 4
The following procedures are advised to be followed: • The WWL-1 should be rinsed thoroughly in fresh water after each dive. • Dry and clean the glass surface of the WWL-1 with the cloth provided. • Cover the lens with the provided covers when not in use.
Need help?
Do you have a question about the WWL-1 and is the answer not in the manual?
Questions and answers