Philips Cineos 37PF9730/10 User Manual page 12

Settings/Setup
Preferences
Picture/sound preferences
Features preferences
Menu preferences
Factory settings
Info
12
Menu preferences
&
é
Menu preferences
OSD
Programme title
Set/Change code
&
é
&
é
"
Important:You have forgotten your code !
&
é
"
&
é
"
OSD
Select .
OSD
Press the cursor right to select
to activate the continuous display of the channel number (for 10
Normal
minutes) and extended display of TV channel and programme information
on screen. E.g. information on the main or auxiliary programme, input signal
quality of connected peripheral equipment, the display format and sound
mode.
Minimum to activate the display of reduced channel information.
See Use of the remote control, p. 4, i Display information.
Programme title
Select .
Programme title
Press the cursor right to select
When selected , after the selection of a TV programme or after pressing
Yes
the i key on the remote control, a TV channel may transmit the name of
the TV channel or the programme title.
When selected , the programme title will only appear after pressing the
No
i key and not after the selection of a TV channel.
Set/Change code
Select or
Set Change code
If no PIN-code exists yet, the menu item is set to
instructions on screen.
If a PIN-code has previously been entered, the menu item is set to
code . Follow the instructions on screen.
All number combinations from 0000 tot 9999 are valid numbers.
The Menu preferences menu
the PIN has been created.
Select Change code in the Menu preferences menu and press
Press the cursor right and enter the overriding code 8-8-8-8.
Press the cursor again and enter a new personal 4-digit code.The previous
code is erased and the new code is stored.
Factory settings
This function allows you to reset most of the picture and sound settings to
their predefined factory states.
Select Factory settings with the cursor down.
Press the cursor right.
Press the key to erase settings and reset them to their default values.
OK
Normal or Minimum .
or
Programme title Yes
with the cursor down.
Set code
reappears with a message confirming that
.
No
. Follow the
Change
.
OK