Related Manuals for ETS 5461
Summary of Contents for ETS 5461
- Page 1 Desiccant / Pump Dehumidification System Model 5461 Operating Manual D01083 Revision A - 2019/10/28...
-
Page 2: Table Of Contents
Table of Contents I. Important Safety Information II. Description of Contents III. Set-Up Guide IV. Operation V. Description and Specifications VI. Maintenance and Calibration VII. Desiccant VIII. Warranty Page 2 3101 Mt Carmel Ave. Glenside, PA │ 833-ENV-GURU (833- 368-4878) -
Page 3: Important Safety Information
I. Important Safety Information SAFETY INSTRUCTIONS The equipment described in this Manual is designed and manufactured to operate within defined design limits. Any misuse may result in injury, electric shock or fire. To prevent the equipment from being damaged, the following rules should be observed for installation, use and maintenance. Read the following safety instructions before operating the instrument. -
Page 4: Description Of Contents
II. Description of Contents Included: Item Qty. Description Model 5461 The Model 5461 Dehumidification System is housed in a 7” W x 7” L x 5” Dehumidification H plastic enclosure with vibration isolating feet. System MS desiccant column 1 L. -
Page 5: Set-Up Guide
North American 3-prong plug to fit into the DECREASE outlet on the rear panel. When used with most ETS 5500C Series Controlled Environment Chamber, input / output fittings and circulating fans will already be installed. For other installations it is recommended that a 32-110 cfm fan(s) be installed to evenly distribute the air within the chamber. - Page 6 Step 3 - Cut to length and connect a piece of tubing between the chamber output fitting and the Model 5461 Air Input Fitting. Connect a second piece of tubing from the Column Output Fitting to the return fitting on the chamber.
-
Page 7: Operation
Both input and output have filter pads to cut down on desiccant dust. V. Description and Specifications The Model 5461 Desiccant Dehumidification System is a closed loop system, designed to reduce the relative humidity within a sealed chamber to less than 10%. When used with an Automatic Humidity Controller, such as the ETS Model 5100 or Model 5200 Microprocessor Humidity Controllers, the chamber may be maintained to within ±... -
Page 8: Maintenance And Calibration
VI. Maintenance and Calibration Calibration No manufacturer conducted calibration is required. Maintenance & Repair To return equipment to ETS for maintenance it is first necessary to obtain a RMA number, please call 215-887-2196 or email service@ets2.com VII. Desiccant CHANGING THE DESICCANT 1. -
Page 9: Warranty
The buyer is expected to expressly waive rights to any warranty other than that stated herein. ETS must be notified before any equipment is returned for repair. ETS will issue an RMA (Return Material Authorization) number for return of equipment.
Need help?
Do you have a question about the 5461 and is the answer not in the manual?
Questions and answers