Power-Up Modes; Panel Power Off/On - Toshiba L40 Series User Manual

Installing the battery pack
To install a battery pack, follow the steps below.
The battery pack is a lithium ion battery, which can explode if not properly
replaced, used, handled or disposed of. Dispose of the battery as required
by local ordinances or regulations. Use only batteries recommended by
TOSHIBA as replacements.
1. Turn the computer's power off.
2. Disconnect all cables connected to the computer.
3. Hold the battery pack so that the label faces down and the connectors
on the battery face the connectors on the computer.
4. Put the battery into the battery bay until the latch clicks into place.

Power-up modes

The computer has three power-up modes:
■
Hibernation (saves data in memory to the hard disk)
■
Sleep (power remains on, maintaining the data in memory, but the CPU
and all other devices effectively enter a 'sleep' mode)
■
Boot (does not save data in memory)
Refer also to the section
Started.

Panel power off/on

This feature makes the computer to enter Hibernation when the display
panel is closed and turns it back on when the display panel is opened.
User's Manual
1
2
Turning off the power
Power and Power-Up Modes
in Chapter 3, Getting
6-10