Installing Ac Output Power Cables - Huawei SUN2000-50KTL-M0 Quick Manual

If the screws on the enclosure door are lost,
obtain spare screws from the fitting bag
bound to the inductor cover at the bottom of
the enclosure.
3. Remove the cover and hang it on the hook of the enclosure door.
4.4

Installing AC Output Power Cables

•
For the SUN2000-50KTL/60KTL-M0:
− If you connect a ground cable to the ground point on the enclosure in a scenario with no
neutral wire, you are advised to use a three-core (L1, L2, and L3) outdoor cable.
− If you connect a ground cable to the ground point in the maintenance compartment in a
scenario with no neutral wire, you are advised to use a four-core (L1, L2, L3, and PE) outdoor
cable.
− If you connect a ground cable to the ground point on the enclosure in a scenario with a neutral
wire, you are advised to use a four-core (L1, L2, L3, and N) outdoor cable.
− If you connect a ground cable to the ground point in the maintenance compartment in a
scenario with a neutral wire, you are advised to use a five-core (L1, L2, L3, N, and PE) outdoor
cable.
•
For the SUN2000-65KTL-M0:
− If you connect a ground cable to the ground point on the enclosure, you are advised to use a
three-core (L1, L2, and L3) outdoor cable.
− If you connect a ground cable to the ground point in the maintenance compartment, you are
advised to use a four-core (L1, L2, L3, and PE) outdoor cable.
1. Remove the locking cap from the AC OUTPUT cable gland and then remove the plug.
2. Route the cable through the cable gland.
1. Select an appropriate rubber fitting based on the outer diameter of the AC power cable to
ensure proper sealing.
2. To avoid damaging the rubber fitting, do not route a cable with a crimped OT terminal through
the rubber fitting.
3. Do not adjust the cable when the thread-lock sealing nut is tightened. Otherwise, the rubber
fitting will shift, which affects the Ingress Protection Rating of the device.
Position for saving spare screws
7