Power Supply; Maintenance - DeWalt DWB6800 Manual

Connecting to the Mains
The mains supply to be used for this machine must
be equipped with a 16 A cut-out fuse with time delay.
Voltage Drops
Inrush currents cause short-time voltage drops.
Under unfavourable power supply conditions, other
equipment may be affected.
If the system impedance of the power supply is lower
than 0.11 Ω, disturbances are unlikely to occur.

POWER SuPPLy

Be sure your power supply agrees with the
nameplate marking. A voltage decrease of more than
10% willcause a loss of power and overheating.
use
Mounting The nozzle for Blowing
Operations (fig. a)
• Insert the pin located inside the Nozzle (A) into
the notch provided on the Blast Port (B)
• To lock Nozzle in place, turn the Nozzle in the
direction indicated.
• To remove Nozzle, turn the Nozzle in the
opposite direction.
Mounting The nozzle and Dust for
DustCollection (fig. B)
• For dust collection, mount the Dust Bag at the
Blast Port (B) and Nozzle at the Suction Port (F).
• To remove Dust Bag and Nozzle, simply pull
out by first turning in the opposite direction.
• Empty the Dust Bag frequently to ensure
maximum dust collecting efficiency.
Operating The Blower (fig. C)
• To switch your Blower on, depress the Switch (C).
To stop your Blower, release Switch.
• Adjust Variable Speed Knob (D) for different
speed requirement.
• When continuous operation is required, first
depress the switch and then the lock-on
button (E) and release to disengage lock,
squeeze and release switch.
WARNING: Continuous running
of machine should not exceed 30
minutes.
Replacing Carbon Brushes (fig. D)
• Use a screwdriver to remove the brush holder cap.
• Take out the worn carbon brush, insert the
new one and secure the brush hold cap.
WARNING: Remove and check the
carbon brushes regularly. Replace
when they wear down to the limit
mark.
accessories
The performance of your tool depends on the
accessory used. DEWALT accessories are
engineered to high quality standards and designed to
enhance the performance of your tool. By using these
accessories you will get the very best from your tool.

MaInTEnanCE

Your D WALT power tool has been designed to
e
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
WARNING: Before performing any
maintenance, switch off and unplug
the tool.
• Regularly clean the ventilation slots in your tool
using a soft brush or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of
the main housing with dry air as often as
dirt is seen collecting in and around the
air vents. Wear approved eye protection
and approved dust mask when
performing this procedure.
E ng l i s h
5