Install The Ptz Driver - Axis T99A Series Installation Manual

AXIS T99A Positioning Unit
1
Bottom cover gasket
2
Camera housing cover screw (T20, x4)
11. Mount the top cover to the bottom cover, and alternately tighten the four cover screws
a few turns at a time until all screws are tight (T20, torque 1.5 Nm). This helps ensure
that the gasket in the bottom cover is compressed evenly.

Install the PTZ driver

This Axis product supports several PTZ devices. For a complete list of supported devices, see
www.axis.com.
A PTZ driver is required to use this product with a PTZ device.
Important
Some cameras may need to be installed upside down in the camera housing, and some
may use the auto-rotation feature. Before installing the PTZ driver, modify the image
settings in the Live View page of your camera to rotate the image right side up, and disable
auto-rotation.
To install the PTZ driver from the Live View page of your camera:
1. Go to PTZ > Driver Selection.
2. Click Browse to locate the wanted driver (e.g. driver.ptz), and then click Upload.
3. Select the uploaded driver from the Select driver to use drop-down list.
30