Connecting An Hdmi Device; Connecting A Dvi Device; Selecting The Pc/Hdmi1 Audio Mode; Setting The Hdmi1 Audio Mode - Toshiba 37X3000A Owner's Manual

Connecting an HDMI device

One HDMI cable (type A connector)
TV back view
HDMI device
For proper operation, it is recommended that you use a short
HDMI cable.
HDMI cable transfers both video and audio.
Note:
It is possible that some HDMI device may not operate properly
with this TV.

Connecting a DVI device

One HDMI (type A connector)-to-DVI adapter cable and
audio cables
TV back view
PC/HDMI1
(AUDIO)
DVI device
VIDEO AUDIO
L
HDMI (type A connector)-to-DVI adapter cable
For proper operation, the length of an HDMI-to-DVI adapter
cable should not exceed 3m. The recommended length is 2m.
Standard analog audio cables
An HDMI-to-DVI adapter cable transfers only video.
Separate analog audio cables are required.
Note:
HDMI, the HDMI logo, and High-Definition Multimedia
Interface are trademarks or registered trademarks of HDMI
Licensing, LLC.
36
Connecting your TV
VIDEO AUDIO
L R
IN
HDMI OUT
OUT
TV back view
DVI
OUT
R
IN
OUT

Selecting the PC/HDMI1 audio mode

You can select PC audio or HDMI1 audio when using this
function (- page 35).
1 Press M, then press Y or Z to display the SET UP
menu.
2
Press V or U to select AV connection, then press Q
to display the AV connection menu.
AV onne tion
PC/HDMI1 audio
HDMI1 audio
AV output
MENU Ba k EXIT
3
Press V or U to select PC/HDMI1 audio, then press Y
or Z to select PC or HDMI1.

Setting the HDMI1 audio mode

You can select sound of an HDMI or DVI device connected to
the HDMI1 input terminals (- page 35) from three modes:
Auto, Digital or Analog.
Note:
This function is available only when the PC/HDMI1 audio mode
HDMI1
is set to .
1 From the AV connection menu, press V or U to select
HDMI1 audio.
AV onne tion
PC/HDMI1 audio
HDMI1 audio
AV output
MENU Ba k EXIT
2
Press Y or Z to select Auto, Digital or Analog.
When the sound is not audible:
If no sound comes out while receiving HDMI signal, the sound
may be audible when using this function set to off.
1
From the HDMI1 audio item in the AV connection,
press and hold Q until the Lip Sync Latency menu
appears on the screen.
Lip Sync Latency
2 Press Y or Z to select Off.
3
Press on the remote control or ! on the TV right side
panel to switch to the standby mode.
4
Press on the remote control or ! on the TV right side
panel again to switch the power on.
Note:
Depending on some external equipment, the sound may be
audible by turning it off and on again.
PC
Digital
ATV
Wat h TV
HDMI1
Auto
ATV
Wat h TV
On