Installation; Reversing The Door - Inalto Classique IBM323W User Manual

Installation

LOCATION
When selecting a position for your unit you should make sure the floor is flat and firm, and the
room is well ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator.
Also avoid direct sunlight as it may increase the electrical consumption. Extreme cold ambient
temperatures may also cause the unit not to perform properly. This unit is not designed for use in
a garage or outdoor installation. Do not drape the unit with any covering.
When installing the unit, ensure that 10 cm of free space is left at both sides, 10 cm at the rear
and 30 cm at the top of the unit. This will allow cold air to circulate around the refrigerator and
improve the efficiency of the cooling process.
DOOR HANDLE INSTALLATION (OPTIONAL)
1. Take out the screw caps 2. Put the handles into the
from the door handle holes. screw holes and then hit
them to fix.
4. Take out the screw caps 5. Remove the screws and
from the handle screw take the handles down.
holes.
User Manual
3. Cap the screw caps on the
handle screws.
6. Cap the screw caps on the
door handle holes again.
06 07
7. Install the handles into the door handle
holes of the other side in accordance with
the handle installation instructions.
REVERSING THE DOOR SWING
1. Take off knuckle guard. 2. Take off top hinge.
4. Take off middle hinge, left 5. Take off the door of freezing
middle beam screw cap and
screw with a screw driver
inalto.house
3. Take off the door of
refrigerating chamber.
6. Take off hinge assembly with a screw driver,
chamber Assemble lower hinge assembly to left side of
the cabinet with a screw driver. Fix the removed
medium beam screw and screw cap to the right
screw hole position.