Subscribe to Our Youtube Channel
Related Manuals for RVS 718-7
Summary of Contents for RVS 718-7
- Page 1 Instruction Manual OEM Frameless Rear View Replacement Mirror Monitor with 7.3" Dual Display Reverse With Confidence ™...
-
Page 2: Table Of Contents
Introduction......Safety Information......04-06 Before Beginning Installation . -
Page 3: Introduction
NOTE! Please read all of the installation instructions carefully before installing the product. Improper installation will void manufacturer’s warranty. Congratulations on purchasing a Rear View Backup Camera System! With this manual you will be able to properly install and operate the unit. The Backup Camera System is intended to be installed as a supplement aid to your standard rear view mirror that already exists in your vehicle. -
Page 4: Safety Information
Please read the entire manual and follow the instructions and warnings carefully. Failure to do so can cause serious damage and/or injury, including loss of life. Be sure to obey all applicable local traffic and motor vehicle regulations as it pertains to this product. Improper installation will void manufacturer’s warranty. - Page 5 INSTALLATION: • Electric shock or product or disconnected wire may cause a malfunction may occur if this fire. product is installed incorrectly. • While installing the Rear View System be careful with the wire • Use this product within positioning in order to avoid wire the voltage range specified.
- Page 6 If you have questions about this product, contact: Rear View Safety 1797 Atlantic Avenue Brooklyn, NY 11233 Tel: 1.800.764.1028 IN NO EVENT SHALL SELLER OR MANUFACTURER BE LIABLE FOR ANY DIRECT OR CONSEQUENTIAL DAMAGES OF ANY NATURE, OR LOSSES OR EXPENSES RESULTING FROM ANY DEFECTIVE PRODUCT OR THE USE OF ANY PRODUCT.
-
Page 7: Before Beginning Installation
Before drilling please check that no cable or wiring is on the other side of the wall. Please clamp all wires securely to reduce the possibility of them being damaged while vehicle is in use. Keep all cables away from hot/moving parts and electrical noisy components. We recommend doing a benchmark test before installation to insure that all components are working properly. -
Page 8: Installation Guide
Remove the original mirror Remove the original mirror Different cars have Different cars have HOW TO INSTALL MIRROR MONITOR Remove the original mirror Different cars have on your vehicle mak on your vehicle mak on your vehicle mak Original Mirror Installation many methods to many methods to Remove the original mirror... -
Page 9: Viewing Options
Viewing Options The view can be changed with triggers or manually with the wire control. Reverse With Confidence ™... -
Page 10: Wiring
Wiring 5 pin female to left camera 5 pin female to right camera 5 pin female to front camera 5 pin female to backup camera trigger line 1 trigger line 2 Red to ignition +12V Black to GND Green to back car singal Wire control Rear View Safety... -
Page 11: Touch Screen
Touch Screen Operation TOUCH BUTTONS OPERATION 1) Non-Trigger/Reversing trigger state: Turn on/off screen | All other Non-trigger and reversing trigger state:Turn on/off screen In menu setting state: Parameter down states: Not used The others state: unusable full display screen: short press to enter into “menu setting” interface Non-trigger state: split screen: unusable 2) Menu State: Parameter down... -
Page 12: Menu
MENU SETTING In “ full display screen” state, short press “ “ ” to enter into menu setting interface .“ ” ” and “ ” are to Menu change the figure of each setting. BRIGHTNESS In full display mode, short press menu to toggle options and use the About “WIRE CTR DELAY”... -
Page 13: Grid Lines
Grid Lines Generally, to help drivers estimate the distance from obstacles, there are three lines for reference- red, yellow, and green. Those three lines are dis- played on the monitor when car is reversing. The green line is 9.9 feet from the back of the car and the yellow line is 6.6 feet away. - Page 14 Grid Lines Reversing State: Long press "Menu" to enter guide adjustment mode. We adjust left guide line first. Use the arrow keys to rotate the guid line coun- terclockwise and clockwise. Counterclockwise Clockwise Short Press: Next item Longe press: save setting and exit Short press "Guide Line Set"...
-
Page 15: Specifications
Screen Size 7.3" TFT-LCD Display Aspect Resolution 1280 (H) X 390 (V) Working Voltage DC10V-DC16V Signal System PAL/AUTO/NTSC Operating Temperature -20°C ~ +65°C Mirror monitor with 7.3" dual display Ultra reflective - acts as mirror as well as monitor 4 Channel - can attach up to four cameras Adjustable distance grid lines for backing up reference Sleek frameless design Reverse With Confidence ™... -
Page 16: Warranty
ONE YEAR WARRANTY REAR VIEW SAFETY, INC. WARRANTS THIS PRODUCT AGAINST MATERIAL DEFECTS FOR A PERIOD OF ONE YEAR FROM DATE OF PURCHASE. WE RESERVE THE RIGHT TO REPAIR OR REPLACE ANY SUCH DEFECTIVE UNIT AT OUR SOLE DISCRETION. REAR VIEW SAFETY, INC. IS NOT RESPONSIBLE FOR A DEFECT IN THE SYSTEM AS A RESULT OF MISUSE, IMPROPER INSTALLATION, DAMAGE OR MISHANDLING OF THE ELECTRONIC COMPONENTS. -
Page 17: Disclaimer
DISCLAIMER REAR VIEW SAFETY AND/OR ITS AFFILIATES DOES NOT GUARANTEE OR PROMISE THAT THE USER OF OUR SYSTEMS WILL NOT BE IN/PART OF AN ACCIDENT OR OTHERWISE NOT COLLIDE WITH AN OBJECT AND/OR PERSON. OUR SYSTEMS ARE NOT A SUBSTITUTE FOR CAREFUL AND CAUTIOUS DRIVING OR FOR THE CONSISTENT ADHERENCE TO ALL APPLICABLE TRAFFIC LAWS AND MOTOR VEHICLE SAFETY REGULATIONS. - Page 18 If you have any questions about this product, contact: Rear View Safety, Inc. 1797 Atlantic Avenue Brooklyn, NY 11233 800.764.1028 Vehicle Safety - It's All We Do. Rear View Safety...
Need help?
Do you have a question about the 718-7 and is the answer not in the manual?
Questions and answers