Programming The Remote Control For Use With A Vcr, Or Cable Tv Converter - Toshiba 23HLV84 Owner's Manual

Programming the remote control for use with a VCR,
or cable TV converter
This remote control is pre-programmed to operate Toshiba VCRs. To
control VCRs, or cable converters other than Toshiba models, you
must follow the steps below to program your remote control.
1. While holding down the CODE button, press the button for the
device you want to control (VCR, or CABLE).
2. Enter the 2-digit code listed on page 24 using the Number buttons
(0-9) within 10 seconds.
3. Point the remote control at the VCR, or converter and press
POWER to test the code.
• If the VCR, converter turns on, you have entered the right code.
• If the VCR, or converter does not respond to the remote control,
you may have entered the wrong code. Repeat steps 1–2 with
another code.
For future reference, write down the codes you used:
VCR code
Cable TV converter code
J5P00101A(E)P22-28 23
POWER
TV(DVD) VCR
1 2 3
4 5 6
7 8 9
CH +
VOL
– ENTER
CH –
EXIT/
INPUT PIC SIZE
CANCEL
RECALL/
SLEEP MUTE
DISPLAY
SUBTITLE AUDIO DVD MENU
PLAY MODE RETURN REPEAT A-B
JUMP CH RTN/ZOOM
REW/SEARCH PLAY
Notes:
• When shipped from the factory, the remote
control is set to operate your TV/DVD.
• If you do not enter the code within 10
seconds from step 1 or if you enter a code
not listed below, this operation is canceled.
• Each time you replace the batteries, you
must reprogram the remote control.
• Some newer VCRs are capable of working
on either of two remote codes. These VCRs
have a switch labeled "VCR1/VCR2."
If your VCR has this kind of switch and
does not respond to any of the codes for
your VCR, set the switch to the other
position (VCR1 or VCR2) and reprogram
the remote control.
23
8/12/04, 11:32 AM
VCR
CABLE
Cable
TV/DVD
100
0
VOL
+
MENU/
SETUP
CODE
Code
TOP MENU
ANGLE
SKIP
FF/SEARCH