Connecting An Amplifier Equipped With A Digital Audio Input; Connecting A Pc (Personal Computer) - Toshiba 23HLV84 Owner's Manual

Connecting an amplifier equipped with a
digital audio input
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by
connecting an amplifier equipped with a digital audio input and speaker
system (right and left front speakers).
Rear lower right of TV/DVD
To COAXIAL
DIGITAL AUDIO
OUT

Connecting a PC (Personal Computer)

Before you connect this TV/DVD to your PC, change the adjustment of
your PC's Resolution and Refresh rate. See "Monitor Display modes"
at right.
Connect one end of a (male to male) VGA cable to the video card of
the computer and the other end to the VGA connector PC at the back
of the TV/DVD. Fix the connectors firmly with the screws on
the plug. In case of a Multimedia computer, connect the audio cables
to the audio outputs of your Multimedia computer and to the AUDIO L
and R connectors of the PC IN jacks of the TV/DVD.
Press INPUT and number button 5 on the remote control to select PC
mode.
Switch on the computer. The TV/DVD can be operated as the
computer monitor.
Rear lower right of TV/DVD
J5P00101A(E)P11-21 20
Amplifier equipped with a
Digital audio input
To COAXIAL
type digital
audio input
To PC
You will need:
• one coaxial cable
Notes:
• PCM audio is limited to DVD or CD
playback.
• Connect the COAXIAL DIGITAL AUDIO
OUT jack of the TV/DVD to the "COAXIAL"
input of a Receiver or Processor.
• Refer to the owner's manual of the
connected equipment as well.
• The output sound of the TV/DVD has a wide
dynamic range. Be sure to adjust the
receiver's volume to a moderate listening
level. Otherwise, the speakers may be
damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or
disconnect the TV/DVD's power cord. If you
leave the amplifier power on, the speakers
may be damaged.
You will need:
• one VGA cable
Monitor Display modes
MODE Resolution
VGA 640x480
SVGA 800x600
SVGA 800x600
XGA 1024x768
To return to TV mode:
Press INPUT again.
Notes:
• The current signal source does not display
when you return to TV mode.
• The form of a character of OSD in PC mode
differ from TV or DVD mode.
20
8/12/04, 11:24 AM
Refresh rate
60Hz
56.3Hz
60.3Hz
60Hz