1 Preliminary note This document is intended for specialists� These specialists are people who are qualified by their appropriate training and their experience to see risks and to avoid possible hazards that may be caused during operation or maintenance of the device�...
2 Safety instructions These instructions are part of the device� They contain texts and figures concerning the correct handling of the device and must be read before installation or use� Note the safety instructions� Use the device in accordance with its designated use� The installation and connection must comply with the applicable national and international standards�...
The following accessories are needed for the operation of the camera: Description Article no�: Power supply cable for camera/sensor EVC070 M12 industrial Ethernet connection cable E11898 The ifm Vision Assistant software is available free of charge on our website: → Service → Download → Industrial imaging www�ifm�com...
Smart Camera mounting set E3D301 Smart Camera cooling element E3D302 Smart Camera heat conductor E3D303 2x Smart Camera cooling element E3D304 You can find more information about the accessories at: → Data sheet direct → e.g. O3D303 → Accessories www�ifm�com...
7 Electrical connection ATTENTION Depending on the operating mode, the unit may heat up� The difference between the unit's surface temperature and the ambient temperature may not exceed 25 degrees� Take one or several of the following measures: ► Adjust the operating mode� ►...
2 - cascading You can find more information about the accessories at: → Data sheet search → e.g. O3D303 → Accessories www�ifm�com 8 Approvals/standards The CE declaration of conformity is available at: → Data sheet search → e.g. O3D303 → Approvals...