Advertisement
Connection options and operating elements
P11
P9
P11
P10
P2
P6
P2
P8
P7
P3
P4
P5
Dismantling when using
round cables
24. Remove the output connector P1 as indi-
cated for release variant 1.
25. Remove any existing cable connectors as
indicated in P21.
26. Open the fixing clip P14 as indicated above.
27. If no distribution block P12 has been used,
the supply connector P6 or P7 is removed
as shown for release variant 2. The EIB
connector P8 can be removed without
using a tool.
28. If the distribution block P12 has been used,
and the supply of further modules is not to
be
interrupted, remove only the distribution
block from the switching device, as indica-
ted for release variant 2. The supply plugs
and extension cables on the distribution
block P12 remain connected.
29. If required, the supply and extension cable
connections on distribution block P12 can
be removed as described in release variant
1. EIB connectors P8 and P11 can be remo-
ved without using a tool.
30. Unscrew the switching device by loosening
the countersunk screws (P13 and P19).
P11
P12
P9
P11
P10
I m p o r t a n t n o t e
The appropriate standards, guidelines, regulations and conditions for setting up electrical installations should be complied with
as well as the relevant safety specifications.
The device must be protected from damp, dirt and from being damaged. The device may not be operated outside the specific
technical data.
Mounting dimensions when using the round
cable for supply
Data in mm
349
254
PROGRAM
PHYSICAL ADDRESS:
230/400V
50/60Hz;
16A
12 x 5,5
P14
P13
P15
P16
P17
P1
P22
Mounting dimensions when using the flat
cable for supply
Data in mm
60,5
14
32
12 x 5,5
35
P18
PROGRAM
PHYSICAL ADDRESS:
7 x 5,5
P19
P20
P21
7 mm
230
7 x 5,5
PROGRAM
PHYSICAL ADDRESS:
230/400V
50/60Hz;
10A
187
Advertisement
