Brinkmann Maxfire Dual LED Owner's Manual & Operating Instructions page 3

Table of Contents

Advertisement

Available languages

Available languages

INS_800-2250-1_DLEDMarine.qxd
READ AND FOLLOW ALL SAFETY WARNINGS AND INSTRUCTIONS IN THE OWNER'S MANUAL
Step 1: Depress trigger switch in handle to turn spotlight ON.
Step 2: Release trigger switch to turn spotlight OFF.
Continuous Beam Using Lock Button:
Step 1: For a continuous beam, depress trigger switch and slide the lock button
to the LOCKED position.
Step 2: To unlock and turn spotlight OFF, slide the lock button to the
UNLOCKED position.
N N o o t t e e : :
To lock the Dual LED in the OFF position, release trigger switch, then
slide the lock button to the LOCKED position.
WARNING:
Always turn spotlight off when not in use.
Switching Between Single and Dual Beams:
Step 1: For single beam, slide switch on back of light to one dot, as illustrated.
Step 2: For dual beam, slide switch on back of light to two dots, as illustrated.
N N o o t t e e : :
The Dual LED will burn for approximately 3 hours if using both beams,
or approximately 4.5 hours if using only one beam.
S S t t e e p p 1 1 : : Make sure trigger switch is not locked in the ON position.
S S t t e e p p 2 2 : : Plug the AC charger or DC charger/adapter into the socket located
on the base of the spotlight handle as illustrated.
Always Allow Battery to Fully Charge
S S t t e e p p 3 3 : : F F o o r r D D C C C C h h a a r r g g e e r r / / A A d d a a p p t t e e r r : : Plug the other end of the DC
charger/adapter into a 12-volt DC receptacle. LED indicator on base
of handle turns off automatically when battery is fully charged.
F F o o r r A A C C C C h h a a r r g g e e r r : : Plug the other end of the AC charger into a wall
outlet. LED indicator on base of handle turns off automatically when
battery is fully charged.
S S t t e e p p 4 4 : : Allow the spotlight to charge for at least 8 hours. Do not allow
to charge more than 12 hours.
N N o o t t e e : :
LED indicator on base of handle turns off automatically when battery
is fully charged.
S S t t e e p p 5 5 : : Remove spotlight from the charger before operating.
S S e e e e c c h h a a r r t t f f o o r r r r e e c c o o m m m m e e n n d d e e d d c c h h a a r r g g e e t t i i m m e e s s . .
12/16/09
3:39 PM
OPERATING INSTRUCTIONS
BEFORE OPERATING SPOTLIGHT.
Page 3
To Operate
Trigger
Switch
Unlocked
Locked
To Charge
Charge time is dependent on usage of the
product. See chart below for recommended charge time.
4
2
CHARGE TIME (HOURS)
Beam
Switch
Lock
Button
Single
Beam
Dual
Beam
LED Indicator
Charge Times
Battery Charge
4
8
12
2

Advertisement

Table of Contents
loading

Table of Contents