Other Functions (Vcr); Stereo Recording And Playback; Second Audio Program (Sap) - Toshiba SD-V392SU Owner's Manual

Other functions (VCR)

Stereo recording and playback /

Second Audio Program (SAP)

Stereo recording and playback
The VHS Hi-Fi audio system permits high fidelity record-
ing of MTS STEREO TV broadcasts.
When a MTS STEREO broad-
cast is received, "STEREO" will
appear on the screen for about 4
seconds and the program can
be viewed or recorded in stereo.
The Hi-Fi stereo recording pro-
cedure is the same as for normal
recordings.
Note:
When using a CATV system, stereo TV programs may be
transmitted over a mono cable channel. In this case
"STEREO" will not appear and the sound will be in mono.
AUDIO SELECT
AUDIO
Output selection
When viewing an MTS stereo TV program, or playing a
prerecorded VHS Hi-Fi stereo videotape, press AUDIO
SELECT to select how the audio will be heard through
the speakers. Normally set to the Hi-Fi stereo position,
this button can be set to the MONO position if the stereo
broadcast or videotape audio is of poor quality. The "R"
and "L" positions allow the audio from the Right or Left Hi-
Fi channel to be heard over both TV speakers. This
button has no effect when viewing a MONO videotape or
TV program. Each time when you press the button,
OUTPUT SELECTION display appears on the screen for
several seconds. Refer to the chart below.
OUTPUT SOUND HEARD ON BOTH
SELECTION SPEAKERS
STEREO STEREO
L CH LEFT CHANNEL AUDIO
R CH RIGHT CHANNEL AUDIO
MONO MONO
2C53301C (E)p38-41
STEREO
39
Second Audio Program (SAP)
Your DVD/VCR is fitted with a SAP broadcast system which
enables you to switch to a second audio program when
viewing a selected channel.
This function applies only when the program is broadcast
in multi-languages through the SAP broadcast system.
1 Press VCR MENU. Then press SET + or – to
select "SAP".
SET +
VCR MENU
SETUP
CH – CH +
ENTER
SET –
2
Press ENTER to select "ON".
Then press VCR MENU until the
menu screen is cleared.
VCR MENU
SET +
SETUP
CH – CH +
ENTER
SET –
Listening to SAP
When the VCR is turned on or a channel selection is
made, make certain the letters "SAP" appears on the
screen for about 4 seconds. This means that the "Second
Audio Program" broadcasting is available.
STEREO SAP
OR
Notes:
• When playing back a tape that is not recorded in Hi-Fi stereo
mode, the audio will automatically be monaural.
• When listening to a VHS Hi-Fi video tape or MTS broadcast
through the VHF/UHF jack (Audio/Video cable not connected),
the sound will be monaural.
21/4/04, 11:12
AUDIO SELECT
SET +/–
VCR MENU
ENTER
CANCEL
á ñ
á ñ
SAP
39