Table of Contents
Advertisement
Remove the Old Carriage
6
a)
Remove the Phillips head screw at the right
side of the carriage cover. This screw holds the
carriage cover on.
b)
With one hand to each side of the carriage,
gently pull the carriage cover tabs out that are
located near where the carriage belts attach to
the carriage and remove the cover
Remove carriage cover screw
c)
Unclip the carriage belt ends at the left and
right sides of the carriage base.
Left
.
Belt Clips
Right
d)
Using a 5/16 (8mm) open end wrench loosen the
#6-32 hex nut ½ turn under the RIGHT and LEFT
swing arms until the washers and round spacers can
move freely.
e)
Hold the carriage at the right and left side of the metal
base with both hands.
Important: Do not hold the carriage by the inkjet head
stalls or the sensor.
f)
Keeping the top two carriage v-wheels on the tra-
verse, gently push the carriage down and rotate
the bottom of the carriage towards the front of the
machine until the lower v-wheels slip off of the lower
traverse rail.
g)
Lift the carriage up and away from the machine. The
long flex cable bundle should follow the carriage as
you pull it off. Set the whole assembly aside.
Press down here
and on the other side
Loosen this nut
Rotate bottom
towards you
Advertisement
Table of Contents
