Connecting To An Audio System And Tv Equipped With Component Video Inputs - Toshiba SD-K740SU Owner's Manual

Component video outputs/inputs
PROGRESSIVE outputs/inputs
Some TVs or monitors are equipped with component video inputs that are capable of reproducing a progressively scanned video
signal. Connenting to these inputs allows you to view the highest quality pictures with less flicker.
INTERLACED outputs/inputs
Some TVs or monitors are equipped with component video inputs. Connecting to these inputs allows you to enjoy the highest quality
DVD picture playback.

Connecting to an audio system and TV equipped with component video inputs

Signal flow
To Y To P To P
B R
VIDEO VIDEO VIDEO
OUT OUT OUT
Component video cable (not supplied)
Notes:
• Actual labels for component video inputs may vary depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, CB, CR)
• In some TVs or monitors, the color levels of the playback picture may be reduced slightly or the tint may change. In such a case,
adjust the TV or monitor for optimum performance.
Notes:
• Refer to the owner's manual of the connected equipment as well.
• When you connect the DVD video player to other equipment, be sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD video player near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the
DVD video player away from the tuner and radio.
• The output sound of the DVD video player has a wide dynamic range. Be sure to adjust the receiver's volume to a moderate
listening level. Otherwise, the speakers may be damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the DVD video player's power cord. If you leave the amplifier power
on, the speakers may be damaged.
• When connecting to a TV using the Video or S-video jack, do not set the COMPONENT/S-VIDEO selector switch to
the COMPONENT position and make the Progressive scan mode On with the PROGRESSIVE button. If you do it, the
Video and S-video outputs do not feed the correct signals and you cannot see any picture. To turn off the
Progressive scan mode, select PROGRESSIVE scan Off (see page 32).
2C01501A P14-17
OUT PUT
COMPONENT DIGITAL
Y
S-VIDEO
L
P COAXIAL
B
OPTICAL AUDIO
P R VEDIO
R
To AUDIO OUT
If the TV has the Component input,
connect the DVD video player with
(red) (white)
the Component cable. When using
the Component cable, do not
Audio cable
connect the yellow video cable.
(not supplied)
Set the COMPONENT/S-VIDEO
selector switch to the COMPONENT
position.
To audio inputs
of the amplifier
(red) (white)
Audio system
15
To wall outlet
TV or monitor with
ColorStream
component video inputs
To P video input
R
To P video input
B
To Y video input
12/16/03, 19:58
®
15