Connecting To An Audio System And Tv Equipped With Component Video Inputs - Toshiba SD-2300 Service Manual

Connecting to an audio system and TV equipped with component video inputs

Signal flow
VIDEO
S
To P To P To Y
R B
VIDEO VIDEO VIDEO
OUT OUT OUT
Component video outputs/inputs (ColorStream
Some TVs or monitors are equipped with component video
inputs. Connecting to these inputs allows you to enjoy
higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex. Y, R-Y, B-Y or Y, C
C )
R
In some TVs or monitors, the color levels of the playback
picture may be reduced slightly or the tint may change. In
such a case, adjust the TV or monitor for optimum
performance.
VIDEO OUT
Y P P
B R
AUDIO OUT
R L BITSTREAM/
PCM
ANALOG
(red) (white)
To ANALOG AUDIO OUT
To Y video input
To P video input
B
To P video input
R
® )
To audio inputs of the amplifier
TV or monitor with
component video inputs
,
B
Notes
• Refer to the owner's manual of the connected equipment as
well.
• When you connect the DVD video player to other equipment,
be sure to turn off the power and unplug all of the equipment
from the wall outlet before making any connections.
• If you place the DVD video player near a tuner or radio, the
radio broadcast sound might be distorted. In this case, place
the DVD video player away from the tuner and radio.
• The output sound of the DVD video player has a wide
dynamic range. Be sure to adjust the receiver's volume to a
moderate listening level. Otherwise, the speakers may be
damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the
DVD video player's power cord. If you leave the amplifier
power on, the speakers may be damaged.
AC IN
To wall outlet
(red)
Audio system
Audio system
• Make the following setting.
On-screen display Select:
"Audio Out Select" "Analog 2ch"
(white)
Page
56
58
19