GE PSB42 Owner's Manual & Installation Instructions page 19

SIDE PANELS
Side panels must be used whenever the sides of the
panels will slip into the side case trim. Secure the
panels to the refrigerator with stick-on hook and loop
fastener strips. Order the side panels from the cabinet
manufacturer.
• Cut a notch in the top front corner as shown to allow
clearance for corner keys in the front side trim.
HARDWARE SUPPLIED
• Water filter bypass plug (on some models)
• Toekick
TOOLS AND MATERIALS
REQUIRED
• Tinsnips to cut banding
• Stepladder
• Tape measure
• Gloves
• 5-Gal. Bucket with cover
• Appliance hand truck
• Tubing cutter
• #2 Phillips screwdriver
• Safety glasses
• Pliers
Refrigerator Tubing kits
• Water shut-off valve
• Custom panels for doors and grille panel
• Screws to secure refrigerator to cabinetry
• Stick-on hook and loop fastener strips for
49-1000364 Rev. 0
Installation Instructions
24"
3/16"
1-7/8"
*84"
*3" to 4"
2-9/16"
FLOORING
For proper installation, this refrigerator must be
placed on a level surface of hard material that is
at the same height as the rest of the flooring. This
surface should be strong enough to support a fully
loaded refrigerator, or approximately 1,500 lbs.
(680.39 kg).
NOTE: Protect the finish of the flooring. Cut a large
section of the cardboard carton and place under
the refrigerator where you are working.
GROUNDING THE REFRIGERATOR
WARNING
Electrical Shock Hazard.
Failure to follow these instructions can result in
death, fire, or electrical shock.
The power cord of this appliance is equipped
with a 3-prong (grounding) plug which mates
with a standard 3-prong (grounding) wall receptacle
from this appliance.
Have the wall outlet and circuit checked by a qualified
electrician to make sure the outlet is properly
grounded.
Where a standard 2-prong wall outlet is encountered,
it is your personal responsibility and obligation to
have it replaced with a properly grounded 3-prong
wall outlet.
PRONG FROM THE POWER
PLUG TO CONNECT
2-PRONG OUTLET.
19