Advertisement
Quick Links
FORM FIT
Installation Instructions
Contents
Bumpons
Anti-abrasion pad
Mounting clips with hook
Mounting clips without hook
Pins
#6 x 5/8 Truss Head Screws
#6 x 5/8 Flat Head Screws
Nylon washers
L Brackets
Hook brackets 20.5mm
Hook brackets 26.0mm
Step #4
Hood Protector
4
7
4
3
7
3
4
3
4
1
2
Illustration #1
Clips (Step #4 and #5)
Illustration #2
Step #5a
TOOLS REQUIRED
Phillips Screwdriver
Tape Measure
Clip and Bumpon Locations
8
6
¾
½
4
Clip with Hook
Step #5b
HD-3F07
BMW X5 2007-13
Step #5c & 5d
Advertisement
Related Manuals for FormFit HD-3F07
Summary of Contents for FormFit HD-3F07
-
Page 1: Installation Instructions
FORM FIT HD-3F07 Hood Protector Installation Instructions BMW X5 2007-13 Contents TOOLS REQUIRED Bumpons Anti-abrasion pad Phillips Screwdriver Mounting clips with hook Tape Measure Mounting clips without hook Pins #6 x 5/8 Truss Head Screws #6 x 5/8 Flat Head Screws... - Page 2 Installation Ensure the hood is clean and dry inside Open the hood of the vehicle. and out. Release the hood, but do not open it. Peel and fold an anti-abrasion film pad in half over the edge of the hood, Install the bumpons as shown in underneath each of the three (3) bottom Illustration #1.
- Page 3 Hook Bracket Locations Hook bracket 20.5mm (Step #8and #9) Hook brackets 26.0mm (Step #10) CARE INSTRUCTIONS Clean the protector with a mild soap and water solution or plastic cleaner only. Do not use chemicals or solvents. Periodically check to make sure the bumpons are in place and the protector is secure. Avoid using automatic car washes.
Need help?
Do you have a question about the HD-3F07 and is the answer not in the manual?
Questions and answers