Table of Contents
Advertisement
Set Up
7. Install two, 9-volt alkaline batteries (1). Be sure that
the batteries fully engage the mounting clips by
pushing on the bottom of each battery with your
thumb.
It will take about 30 seconds for the monitor to dis-
play information after pressing the Display button
on the initial power-up. This time will decrease
thereafter to a few seconds
8. Replace insulating foam (4).
Make sure the gasket (2) is not damaged and is in
the correct location.
S1 sets NETWORK ID
S2 sets TRANSCEIVER ID
All dipswitches in down
or off position.
on
1
S1
All dipswitches
to right or off
position.
F
. 2
IG
4
S2
4
2
3
9. Replace cover (7) and secure it with the four screws
(3).
Make sure the cover screws are tightened securely
(18-22 in-lb) to avoid water leakage into the TLM
electronics. If a torque wrench is not used, verify
there are no gaps under the screw heads and no
gaps under the cover flange. This will ensure
proper compression of the gasket for a water-tight
seal.
ti12007a
312964C
Advertisement
Table of Contents
