Advertisement
6
Close the black ink tank cap.
7
Repeat the previous steps for the other colors.
Caution:
After setup, periodically inspect the ink levels to ensure
they do not fall below the
level is lower than the line could damage the product. See the
online User's Guide for refilling instructions.
8
Close the ink tank cover.
9
Connect the power cord to the back of the product and to
an electrical outlet.
Caution:
Do not connect to your computer yet.
10
Raise the control panel, then press the
turn on the product. The
11
Select your language.
Note:
You can change this setting later using the product's
control panel. For more information, see the online User's Guide.
12
When instructed to see the Start Here sheet, press and
hold the
help button for 5 seconds.
lower lines. Prolonged use when any
power button to
power light flashes.
13
Press the
start button to start ink charging.
Note:
Ink charging takes about 10 minutes. When the
light stops flashing, ink charging is complete. Once initial setup
of the printer is complete, you can top off the ink tanks with any
remaining ink. See the online User's Guide for instructions.
Caution:
Do not unplug or turn off the product, or open the
inner cover while the product is charging or you'll waste ink.
14
Press the OK button to proceed with initial setup.
15
Follow the on-screen instructions to adjust the print
quality of your product.
Note:
• You need to load paper before you can adjust the print quality.
See "Load paper" below for details.
• Select Adjust Later if you want to adjust the print quality later.
For more information, see the online User's Guide.
3
Load paper
See the online User's Guide for information about loading
capacity, available paper types and sizes, and loading
envelopes.
1
Make sure the product is not charging ink. Open the
feeder guard then raise the paper support and tilt it
backwards slightly.
2
Slide the edge guides all the way out.
3
Load paper, glossy or printable side up and short edge
first, in the middle of the rear paper feed slot.
Note:
Make sure the paper is under the
guides.
power
mark inside the edge
Advertisement
