Fill - Craftsman 47099 Operator's Manual

FILL FROM A BULK
LUBRICANT CONTAINER
1. While holding grease gun container
tube (6), loosen grease gun head (10)
two turns.
2. Pull T-handle (8) to extend follower rod
(5) fully and slide into slot.
3. Unscrew container tube (6) from
grease gun head (10).
4. Remove empty cartridge (if present)
from container tube (6).
5. Pull T-handle (8) back and remove
follower rod (5) from slot.
6. Pack lubricant into cavity of the grease
gun head (10) and onto surface of the
follower assembly (4).
10
7. Insert the open end of the container
tube (6) into lubricant.
8. Pull T-handle (8) back while pushing
container tube (6) deeper into lubricant
to prevent air pockets from being
pulled into container tube (6).
9. Pull T-handle (8) to extend follower rod
(5) fully and slide into slot.
10. Thread grease gun head (10) onto filled
container tube (6).
11. Pull lever handle (3) away from
container tube (6).
12. Pull T-handle (8) back and remove
follower rod (5) from slot.
13. Turn T-handle (8) 90° and push into
container tube (6)
14. Loosen grease gun head (10) two turns
to expel air and retighten.
4
grease gun will cause it to lose prime.
Air pockets in cartridge will cause lever
gun to lose prime.
coupler (1) after ten strokes of lever
handle (3), refer to Expel.Air.Pockets
section on page.6.
4
!
Notice
Failure to clean and inspect
!
Notice
If grease does not come out of
6
8
5