suprabeam V3air User Manual

User Manual - Headlamps
Thank you for purchasing one of our products.
The following instructions will help you to familiarize with the headlamp,
and are intended to assist you with any general problem or doubt. Please
read them carefully before using the headlamp.

Using your headlamp

The headlamp has four functions and three main light intensities:
• Functions: ON, Dim/memory, Boost and SOS.
• Intensities: Boost, High - Low.
You can access to all of them by pressing and holding the button as
shown on the diagram.
Turning on the headlamp
With the headlamp turned off, press and hold down the button for 1.2
seconds. This will turn on the headlamp in High intensity, or at the last
intensity level used. The headlamp saves the last intensity used in its
memory (removing the battery will erase the memory of the headlamp.
The next time the headlamp is turned on, it will start in High intensity).
Pressing the button quickly will only turn on the headlamp for a
moment. In order to turn it fully on, it is necessary to press and
hold the button down for 1.2 seconds. This is done as a security
measurement, in order to avoid the accidental turning on of the
headlamp while being carried inside a pocket or bag.
Turning on the headlamp and selecting intensity level
With the headlamp turned off, press and hold down the button for 2.4
seconds. The headlamp will turn on in Dim mode. The intensity will
decrease and increase gradually until the button is released. By doing so,
the headlamp will remain turned on at the intensity level selected.
Turning off the headlamp
With the headlamp turned on, simply press the button quickly to turn it
off.
Accessing the Boost intensity
With the headlamp turned on, press and hold down the button for 1.2
seconds to enter the Boost intensity mode.
• While being in Boost mode, press and hold down the button for 1.2
seconds to go back to the previous intensity level used.
• Pressing the button quickly will turn off the headlamp.
Accessing the SOS mode
With the lamp turned on, press and hold down the button for 2.4 seconds.
This will activate the SOS mode.
• Pressing the button quickly will turn off the headlamp.
Press & Hold
Click
0 1.2 2.4
sec sec
LAST LEVEL
USED
Click
0 1.2 2.4
sec sec
OFF BOOST
Click
1.2
sec
OFF
LAST LEVEL
USED
Click
0 1.2 2.4
sec sec sec
LAST LEVEL DIM
USED

Placing the batteries

Pay special attention to the polarity of the batteries when placing them in
the battery pack.
Rechargeable batteries are charged inside the battery pack, when
Click
0 1.2 2.4
connecting the USB cable.
sec sec sec
OFF BOOST SOS
Click
1.2
sec
sec
OFF
LAST LEVEL
USED
DIM
sec
SOS
1