Attaching The Embroidery Frame - Brother PRSCLPM1 Installation Manual

— — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — — —
3 Press down on the lock levers until they click
into place.
1 Lock levers
Memo
● You can hold the fabric at the three
positions of the frame. Use the appropriate
position according to the thickness or
material of the fabric.
● When embroidering a thin or slippery type
of fabric, place the edge near the locking
levers so that the fabric is securely held.
4
Pull the four sides of the fabric to remove
any slack. Finally, check that the fabric is
firmly in place.
Memo
● To correctly hoop the fabric in the
embroidery frame, we recommend using a
flat surface for stability and positioning.
Attaching the embroidery
frame
After hooping the item in the clamp frame, attach
the frame to the embroidery machine.
Note
● When attaching or removing the clamp
frame, make sure that the start/stop button
of the embroidery machine is lit in red. If
the start/stop button is flashing in green,
the embroidery machine may start sewing.
If the embroidery machine accidentally
starts operating, injuries may result.
● Before attaching the clamp frame, install
embroidery frame holder D on the
embroidery machine.
1 Loosen and remove the two thumb screws
on the embroidery machine, and then
remove the embroidery frame holder from
the carriage.
1 Thumb screws
• The removed thumb screws will be used to
install embroidery frame holder D.
2
Insert the pins on the frame-mounting plate
of the carriage into the holes on both sides of
the mounting plate of embroidery frame
holder D.
b
1 Pins on the frame-mounting plate of the
carriage
2 Holes in the mounting plate of embroidery
frame holder D
2/3
a