Operation And Shut-Down; Working With The Machine; Shutting The Machine Down - Beisler 1265-4 Working Instructions

Service Instructions Automatic Single-Head Serging Machine 1265-4
C.4
C.4.1

Working with the machine

Factory settings
The program control of the machine has been programmed with 10
standard sewing programs at the factory:
• Sewing programs M 01 to M 10 for the automated serging of rear
trousers panels and front trousers panels with or without knee lining
made of standard materials.
• The sewing programs M 10 to M 20 are freely programmable.
These sewing programs are so powerful that they can be used for ser-
ging nearly all common trousers shapes.
They are furthermore perfectly suited for training operating personnel
and can be used as a template for programming customer-specific se-
wing programs.
For details about the programming of sewing programs, please refer to
Section D, Programming Instructions.
C.4.2

Shutting the machine down

If the machine is to be shut down, it must be disconnected from all en-
ergy supply sources.
Disconnecting the machine from the power supply system:
1. Turn the machine off by moving the main switch to position "0".
2. Remove the power plug from the socket and protect it against acci-
dental reconnection.
Disconnecting the machine from the compressed-air supply sys-
tem:
1. Shut off the on-site compressed-air supply system.
2. Remove the compressed-air hose plug from the terminal unit.
NOTE - Dust-proof protection
If the machine is to be shut down for an extended period
of time, it should be covered with a plastic tarpaulin.

Operation and shut-down

C-9
Beisler GmbH