Using The Headset And Belt Clip (Option) - Toshiba SG-1801 Owner's Manual

USING THE HEADSET AND BELT CLIP (OPTION)

For purchase of an optional accessory, please call 1-877-644-7373.
HEADSET
You can use an optional headset (part#: RC 008260) that has a 3/32-
inch (2.5mm) plug.
NOTES:
• The handset's earspeaker and microphone are turned off with a headset
connected.
• Pressing the VOL
headset's volume.
• If you place the handset on the base unit while the headset is connected, be
sure the handset is placed properly.
BELT CLIP
You can attach an optional Belt Clip (part # RC009263) to the handset in
order to carry it on your belt.
Attaching the Belt Clip to the Handset
Removing the Belt Clip from the Handset
Pull both sides of the Belt Clip to release the tabs from the grooves.
NOTE:
Remove the Belt Clip carefully from the handset, taking care not to hurt your
fingers or damage your nails.
To connect the headset, open the rubber
cover on the left side of the handset, then
insert the headset's plug into the jack.
With a headset connected, you can make or
answer calls as usual using the keys on the
handset.
When you finish using the headset,
disconnect it from the handset and close the
rubber cover to protect the jack.
(L,M) button of the handset also controls the connected
Insert the Belt Clip tabs into the holes on
each side of the handset until they click.
NOTE:
Be sure to insert the tabs properly into each hole to
prevent the Belt Clip from falling off.
INSTALLATION
17