Kasco marine 3.1EVX Owner's Manual page 21

STEP FOUR
Turn the assembly upside down and place the Bottom
Float Brackets (Part B3) over the bolts, the ends of
which should now be extending through the assembly.
Loosely install the six Lock Nuts (Part B5) on the ends
of the bolts (do not tighten yet).
(For 3.1EVFX, 3.3E(H)VFX)
Connect the top and bottom brackets using three 3/8"
x 1" Bolts (Part B6) with the three 3/8" Nuts (Part
B5) and tighten using the 9/16" (14mm) wrench and
socket.
STEP FIVE (For 8400EJ, 2.3EJ, 3.1EJ, 3.3EJ, &
5.3E(H)JF)
Rest the fl oat on the base plate of the unit. Connect
the fl oat to the base plate using the 3/8" x 1" bolt (Part
#B6) and 3/8" lock washer (Part #B7). Tighten using
a 9/16" wrench.
STEP FIVE (For 3.1EVFX, 3.3E(H)VFX models)
Return the assembly to the upside down position and
place the motor assembly (Stainless Steel can side
up, black tube down) in the center of the fl oat. Align
the 3 taller legs of the black fountain tube with the 3
fl oat brackets. Attach the motor to the fl oat using the
1/4" x 1" bolts. Attach to the fl oat bracket using the
two middle holes of the fl oat bracket. Tighten us-
ing the 1/4" x 1" Bolts with 1/4" Lock Washers using
the 7/16" socket and wrench. The 1" bolts will screw
directly into the legs of the black fountain tube.
STEP SIX
Center the Top Screen (Part B10) inside the three Top
Float Brackets. Attach the screen by spanning each
Top Screen Clip (Part B11) across the two innermost
rings on the screen and the hole in the fl oat bracket.
Insert the Brass Screws (Part B14) and attach with
1/4" Lock Washers and 1/4" Nuts to secure the screen
to the fl oat assembly.
STEP SEVEN
Position the Bottom Screen (Part B9) over the fl oat so
the motor housing (can) passes through the large hole
in the center of the screen. Remove the center three
Lock Nuts from the 9" Bolts and place the Bottom
Screen Clips (Part B13) over the bolts as shown. The
power cord can be slid under the bottom screen where
two fl oat sections come together before the Lock Nuts
are replaced. Replace the three inside Lock Nuts and
tighten all 3/8" Lock Nuts using the 9/16" (14mm)
wrench and socket.
7