Table of Contents
Advertisement
FirstCheck+ 1, 2, 3 & 5000
Getting started
Packing List
Please take a little time to check the contents in the FirstCheck+ case.
Item
Description
1.
FirstCheck+ instrument
2.
PID lamp (fitted)
3.
Probe - 100mm (fitted)
4.
PTFE filter - 50 micron (fitted)
5.
Battery charger (if rechargeable type)
6.
Battery clip
7.
Screw driver
8.
Manual
9.
1stPC+
10.
IS Protective Cover
11.
Cal Kit Sample containing:
·
PID lamp cleaning Kit (Includes alumina
powder and 2 applicators for 1 clean)
·
Carbon canister
·
PTFE filter
·
Cal adaptor*
·
Lamp removal tools (neoprene sleeves)
* Please note that the Cal adaptor is to be used in conjunction with a FirstCheck+ Calibration Kit accessory
(part number A-845213).
Calibration kit) ensure that the small breather hole of the Cal adaptor is not covered as this will cause the
instruments internal pump to be damaged beyond repair. Your warranty will be invalidated if the pump is
damaged in this way.
Removing the FirstCheck+ from its case
Carefully remove the FirstCheck+ instrument from its case being careful not to damage the filter and probe
assembly. 'Luer' type connectors are used to connect the FirstCheck+, filter and probe together and requir e
a quarter-turn ONLY to connect / disconnect them. DO NOT over tighten.
To avoid drawing dust or particulate matter into the detector cell we suggest always fitting the filter with the
Ion Science logo facing away from the instrument, therefore dust only collects on the same one si de of the
filter and is not inadvertently drawn into the instrument if the filter is attached the other way round.
Ion Scie nce Lt d
_________________________________
(if non-rechargeable)
(if non-rechargeable)
50 micron
WARNING: when fitting the Cal adaptor onto the gas tube (part of the
Page 8 of 53
Qty.
1
1
1
1
1
1
1
1
1
1
1
1
1
1
2
Ion Science L td
Advertisement
Table of Contents
