Table of Contents
Advertisement
FirstCheck+ 1, 2, 3 & 5000
Protective / Decontamination Cover
Fitting Instructions
1.
Insert instrument into the IS protective cover ensuring that the
probe tip exits through the small slit at the top of the cover and
that the cover labelling and stickers are on the reverse of the
instrument.
2. Seal the cover at its base and lay the instrument on a flat surface
with the label and stickers facing upwards.
3. Peel off the backing to the large section of double -sided tape in the
middle of the instrument.
4. Gather the excess plastic on one side of the instrument and stick it on
the midway point of the double -sided tape.
5. Gather the excess plastic on the other side of the instrument and stick it
to the remainder of the double -sided tape.
6. Now remove the backing from one of the small pieces of tape and secure it
to the side of the instrument.
7. Remove the final piece of backing and secure it to the other side of the
instrument.
8. The instrument is now ready to use in Category 1 (zone 0) areas and in
applications where it is likely to get wet.
Note: this cover does not invalidate the
Intrinsically Safe Rating of FirstCheck+
Ion Scie nce Lt d
Page 47 of 53
Ion Science L td
Advertisement
Table of Contents
