How To Replace The Main Parts - Toshiba RAS-10YAV-E Service Manual

11. HOW TO REPLACE THE MAIN PARTS

11-1. Indoor Unit
No. Part name
Q
Front panel 1) After stopping the operation of the air conditioner,
2) Open the screw caps and remove the two screws
3) Close the screw caps as they were.
4) Open the horizontal louver right below by your
5) Open the lower side of front panel until it touches
1) Fix the two screws to secure the front panel.
2) Close the screw caps as they were.
3) Press four places where are the center, right end,
4) Check the gap between the front panel and the
R
Electrical part 1) Perform the process
assembly
2) Remove the screw securing the shield metal plate.
3) Remove the electrical part cover by pressing the
4) Remove the drain guide.
5) Remove the screw securing to the end plate of the
6) Remove the connector (5p) for the fan motor and
7) After unhooking the electrical part base by press-
8) Pull the TC sensor out from the holder of the heat
9) Dress the connecting cable securely as shown in
S
Drain-pan 1) Perform the process
assembly
2) Remove the drain-pan by pressing the four hooks
Procedure
be sure to turn off the circuit breaker or disconnect
the power plug from the AC wall socket.
fixing the front panel.
finger.
the horizontal louver, and remove it from the indoor
unit by turning it.
<To assemble the front panel>
left end and lower portions of the air outlet.
main unit.
If cooling or drying operation is performed without
pressing the center of the air outlet, the surface of
the front panel may be covered with frost and have
a waterdrop.
Q
above.
nail located on upper portion of the electrical part
cover.
heat exchanger.
the connector (6p) for the louver motor from the
microcomputer assembly.
ing the fixing nail located on its lower portion, draw
the electrical part base out toward you to remove it
from the main unit.
exchanger.
the right illustration.
(Improper dressing will cause water leakage.)
R
above.
downwards. (Keep it with the drain hose.)
– 59 –
Remarks
5
3 2 4 2 3
3 3 3
3
Upper nail
Screw
Drain
guide
Screw
Electrical
part cover
Lower fixing nail
Screw
TC
sensor
When assembling dress the connecting
cable in loop and put it into the drain-pan.
Hooks
5