Advertisement
Quick Links
PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.
DO NOT TIGHTEN
HOSE
*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
VACUUM BREAKER INSTALLATION
- Remove complete trim from vacuum breaker valve.
Install bidet elbow into threaded outlet.
Insert gasket into bidet wye and thread onto bottom of vacuum breaker valve.
Remove black plastic lock nut, nylon slip washer and one black self-seating
china seal.
Insert diverter valve body up from below and reinstall black self-seating china seal,
nylon slip washer and black plastic lock nut being sure to tighten firmly by hand.
- Thread trim cylinder onto vacuum breaker valve and tighten firmly. Place handle on
top and secure with brass screw. Insert handle cap with arrow facing towards front
of bidet
.
KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
COLLECTION
BIDET
This is a general installation instruction
for the following collections:
* MONZA
* NOVO
MINIMUM HOLE SIZE FOR THE SPOUT AND
HANDLE TRIM IS 1
DO NOT TIGHTEN
HOSE
¼
" AND MAXIMUM OF 1
½
"
Handle Cap
Screw
Handle
Trim Cylinder
Black plastic lock nut
White Nylon Slip Washer
Black Soft Seating China Seals
Black Soft Seating China Seals
PAGE 01
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Santec MONZA Series
Summary of Contents for Santec MONZA Series
- Page 1 COLLECTION BIDET This is a general installation instruction for the following collections: PLEASE READ THE INSTRUCTIONS COMPLETELY * MONZA BEFORE BEGINNING THE INSTALLATION. * NOVO DO NOT TIGHTEN MINIMUM HOLE SIZE FOR THE SPOUT AND HOSE HANDLE TRIM IS 1 ¼...
- Page 2 DO NOT DISSASEMBLE. - Remove the valve body mounting hardware from valve body. Fiber gasket Hot valve assembly “Red” to be mounted on left. SANTEC SANTEC Cold valve assembly “Blue” to be mounted on right. Brass lock nut - Apply a ring of silicone caulking around the handle hole on bidet top.
- Page 3 - Test pop-up for smooth operation and adjust if necessary. Lock Nut Side hole Ball Rod Ball Rod Clip Ball Rod Nut Drain Tube SANTEC SANTEC INLET HOSE INLET HOSE INLET HOSE INLET HOSE FLUSH THE LINE - After all connections have been made from inlet supplies to angle stops, remove the spritzer housing, basket and washer.
- Page 4 This warranty does not cover any cost involved in the installation, repair, or replace ment of any Santec product or part. This warranty does not cover and Santec will not be held liable for any loss, damages, or expenses, incidental or consequential whatsoever, originating from the purchase, installation, use, repair, failure, or replaceme nt of any Santec product or part, as allowed by law.
Need help?
Do you have a question about the MONZA Series and is the answer not in the manual?
Questions and answers