Advertisement
3. Remove the return filter cap to let air in and then
loosely attach it.
4. Note the location of the front-motor drain hoses
attached to the manifold and remove them.
5. Insert blanking caps into the holes in the manifold
(Figure
3).
1
G028949
Figure 3
1. Blanking cap
2. Cable tie
6. Attach the 3/8-inch hose to the front tee assembly.
7. Route the hose under the oil tank, lay it on top of the
existing hose bundle, and feed it out of the rear of the
machine.
8. Attach the hoses removed in step
assembly in the same locations they were arranged on
the manifold
(Figure 1
9. Secure the front tee assembly to the hose bundle below
it with a cable tie
(Figure
10. Tighten all of the fittings.
2
3
3. 3/8-inch hose
4
to the front tee
or
Figure
2).
3).
2
Installing the Rear Tee
Assembly
Parts needed for this procedure:
1
3/8-inch to 1/4-inch swivel tee
1
3/8-inch adaptor
1
1/4-inch swivel tee
2
Blanking caps
1
1/4-inch hose
1
3/8-inch hose
Procedure
1. Assemble the rear tee assembly
1
G028948
1. 3/8-inch to 1/4-inch swivel
tee
2. To the oil tank
3. 3/8-inch adaptor
4. To the center, back cutting
unit
2. Remove the rear cover.
3. Remove the 2 motor drain hoses from the rear
manifold.
4. Insert blanking caps into the holes in the manifold
(Figure
5).
2
(Figure
4).
2
3
4
6
7
Figure 4
5. To the rear, right cutting
unit
6. 1/4-inch swivel tee
7. To the front tee
5
Advertisement
