Cutter-Motor Drain-Line Kit
Groundsmaster
Model No. 111-8081
This kit is for Groundsmaster 3400 machines from serial number 315000001 and earlier, and reroutes the cutter-motor
drain-line directly back to the tank to prepare for potential cutter motor replacements.
Before installing this kit, refer to your Groundsmaster Operator's Manual for safety instructions and the product overview.
Important: If after reading these instructions you are still unsure of how to install this kit, contact your Authorized
Toro Dealer for help.
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Description
Blanking plug
1/4 inch tee
3/8 inch adaptor
1. Lower the cutting deck, shut off the engine, remove the
key, and ensure that there is no remaining pressure in
the hydraulic circuit.
2. Raise and support the operator's platform.
3. On the rear of the cutter block, remove the 3/8 inch
drain hose and install a blanking plug in the opening
(Figure
1).
1. 1/4 inch adapter
4. On the front of the machine, loosen the drain-line
bulkhead-fitting.
5. Remove the 1/4 inch adapter and hose from the top
of the oil suction flange.
6. Install the 1/4 inch tee
7. Attach the 1/4 inch adapter and hose from step
the rear of the 1/4 inch tee
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
3400 4-Wheel Drive Traction Unit
1
2
G028912
Figure 1
2. Blanking plug
(Figure
1).
(Figure
2).
Register at www.Toro.com.
Qty.
1
1
Install the kit.
1
Note: Orient the hose as necessary.
1
2
1. New 1/4 inch tee
8. Connect the 3/8 inch adaptor to the front of the 1/4
inch tee.
5
to
Form No. 3394-491 Rev A
Installation Instructions
Use
Figure 2
2. Existing 1/4 inch adapter
and hose
Original Instructions (EN)
All Rights Reserved *3394-491* A
Printed in the UK
G028913