Advertisement
Quick Links
Advertisement
Related Manuals for impekk The Essential-LTM-2L-GA/EL-1
Summary of Contents for impekk The Essential-LTM-2L-GA/EL-1
- Page 1 ELECTRIC TABLE Model: The Essential - LTM-2L-GA/EL-1 Assembly and instructions...
- Page 2 Caution! Make sure there are no obstacles in the desk’s path. Make sure the desktop is not touching any walls. Make sure all cords are of appropriate length to accommodate the change in height. Children should only operate desk under adult supervision. There is a risk of injury and electric shock if not properly installed.
-
Page 3: Parts Included
Parts Included Frame Please note that B & H are preassembled. Electrical components Hardware Control Box Electrical Motor 2.5mm Power Cord Control switch... - Page 4 Assembly instructions Step 1 Complete this step for both legs. Step 2 Part B and H are preassembled. You must adjust them to approximately match the length of your table. Do not tighten the screws completely before the final adjustments. The tabs must be on the floor.
- Page 5 Step 3 2.5mm Insert the shaft into the gearboxes mounted on the legs. Do not tighten the screws completely before the final adjustments. 2.5mm...
- Page 6 Step 4 Complete this step for both legs. Do not overtighten fasteners. Step 5 Map out the desired position of the legs. For maximum stability, center the legs on the table. Adjustable width of 1100 mm to 1600 mm ( 43 ”...
- Page 7 Step 6 Install the legs to the underside of the table top. Adjust the length of the legs and the shaft before you attach the table top. Make sure no screws protrude from the shaft as they would rub against the leg brackets during operation.
- Page 8 Step 6 Install the control switch so that it does not exceed the table top. Install the control box where it won’t interfere with the lift mechanism. Follow the steps below to connect the electric components. When all the connections are done, ask a second person to help you lift up the table. 2 Height setting control buttons.