Remote Control Installation For: Gwh C920 Es/Gwh C920Esc /Gwh C800 Es/Gwh 715 Es/ Gwh 2700 Es/Gwh2400Es/Evolution500/Integra500/ C1210Es/C1210Esc/C1050Es/C950Es/940Es; 940Eso/830Es; Remote Control Transceiver Pcb Installation - Bosch Remote Control Manual
For: gwh 635 es/635 eso/250sx/250sxo/2400e /2400eo/2400es/2700es/715es/c800es/c920es /c920esc/evolution 500/integra 500/c1210es /c1210esc/c1050es/c950es/940es/940eso/830es
Hide thumbs
Also See for Remote Control:
- User manual (20 pages) ,
- User manual (16 pages) ,
- User manual (20 pages)
Table of Contents
Advertisement
5
Remote control installation for: GWH C920 ES/GWH C920ESC /GWH C800 ES/GWH 715
ES/ GWH 2700 ES/GWH2400ES/EVOLUTION500/INTEGRA500/C1210ES/C1210ESC/
C1050ES/C950ES/940ES/940ESO/830ES
5.1
Remote control transceiver PCB installation
WARNING: For safety reasons, disconnect
the power supply to the water heater before
performing installation.
Pre-installation preparation
▶ Loosen the two Philips head screws located on bottom rear
of cover.
▶ Lift front cover upward and remove.
▶ Remove the three screws from the control unit (Fig. 8,
[1]).
Fig. 7
▶ Remove the 6 screws from the back cover of the control
unit, to access the electronic board (PCB) (Fig. 8, [2]).
Fig. 8
Remote Control
Remote control installation for: GWH C920 ES/GWH C920ESC /GWH C800 ES/GWH
6720606990-10.1AL
Remote control transceiver PCB installation
▶ Place the remote control PCB in the back cover of the
control unit as shown in Fig. 9.
Fig. 9
▶ Connect the supplied cable between the main PCB and the
remote control PCB as shown in Fig. 10.
Fig. 10
▶ Reassemble all parts in the reverse order.
6 720 606 990 (2014/06)
Advertisement
Table of Contents
