Table of Contents
Advertisement
Quick Links
NOTE: DO NOT ATTEMPT TO INSTALL THE INTERCEPT PRIOR TO READING THESE INSTRUCTIONS
Step 1. Prepare table per instructions on separate sheet. Be sure to retain portion of cut out tabletop if it will become
the finished top of the INTERCEPT 2.
Step 2. Unpack the INTERCEPT 2, being careful not to damage any part, and check to ensure that no items were
damaged during shipping. Review parts list to be sure all parts are present.
Step 3. TABLE THICKNESS ADJUSTMENT - The INNER PAN ASSY has four (4) adjustable mounting flanges that
can be set for your specific table thickness between .656" - 1.625". The flanges come set for the thinnest table.
To change the flanges remove the lock nuts (2 per flange) and move the flanges to the hole that corresponds
with the table thickness that the INTERCEPT 2 will be mounted in.
Table Thickness
1.375" – 1.625"
Table Thickness
1.125" – 1.375"
Table Thickness
.83" – 1.125"
Table Thickness
.656" - .83"
Tighten the lock nuts; be sure all of the flange tops are at the same height
Step 4. TABLE CUTOUT MOUNTING - Attach CUTOUT PIECE, from table preparation, to top of MAIN HOUSING.
The 8 pilot holes should line up. From underside of the INNER PAN, insert screws (use magnetic screwdriver)
and secure the CUTOUT PIECE to the MAIN HOUSING.
Main Housing
Cutout Piece
ECA • 10 Mountain View Drive • Shelton, CT 06484 • Phone: 1-800-521-3175 • Fax: 203-924-6687
9065-0002 RevF
Intercept 2
Installation Sheet
Innovat ive Power + Dat a Solut ions
www.electri-cable.com
Top of Inner Pan
Flange
Screws
Qty 8
Inner Pan
Assembly
1
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for ECA Intercept 2
Summary of Contents for ECA Intercept 2
- Page 1 INTERCEPT 2. Step 2. Unpack the INTERCEPT 2, being careful not to damage any part, and check to ensure that no items were damaged during shipping. Review parts list to be sure all parts are present.
- Page 2 Step 7. Plug the ROCKER SWITCH ASSY onto the cable utilizing the 4-pin connector, plug in the unit and test for proper operation. By pressing the “Raise” side of the ROCKER SWITCH the INTERCEPT 2 should elevate and lock at top. By pressing the “Lower” side of the ROCKER SWITCH the INTERCEPT 2 should return to the original, retracted, position.
- Page 3 SHUTTER BUSHINGS in the bottom of the MAIN HOUSING. Wires should be dressed to move freely up and down with the movement of the MAIN HOUSING. This step can be done before mounting the INTERCEPT 2 however, be sure all wires are run through the cutout in the OUTER PAN before completing step 5.
Need help?
Do you have a question about the Intercept 2 and is the answer not in the manual?
Questions and answers