BERWICK
™
/ BOULEVARD
DECK MOUNT BATH FILLER
Thank you for selecting American-Standard...
the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--
please read these instructions carefully before you begin.
Recommended Tools
Flat Blade Screwdriver
Adjustable Wrench
Channel Locks
*Supplied with Fitting
1
SPOUT ASSEMBLY
Turn off hot and cold water
CAUTION
supplies before beginning.
Install RING WASHER (1) into spout base recess. Check that
O-RING (2) on end of SPOUT SHANK (3) is in place. Insert SPOUT
SHANK (3) through center hole on mounting surface.
Assemble RUBBER WASHER (4) and BRASS WASHER (5) and
LOCKNUT (6) onto SPOUT SHANK (3). Align SPOUT ASSEMBLY
and from underside of ledge secure SPOUT ASSEMBLY into
position with LOCKNUT (6).
4
5
6
Installation
Instructions
™
ROUGHING-IN DIMENSIONS
286mm
*Hex key
(11-1/4")
SPOUT
ASSEMBLY
SPOUT BASE RECESS
1
2
3
MOUNTING
SURFACE
7430.9XX
7431.9XX
212mm
(8-3/8")
170mm
(6-3/4")
1-1/8 D.
1-3/16" MAX.
(30mm) MAX.
3/4-14 MALE
1-1/16 D.
N.P .T. INLETS
(27mm) D.
2
PREPARE TUBE AND TEE ASSEMBLY
Prepare TUBE and TEE ASSEMBLY (1) to fit center to center
VALVE (2) location (between 6-1/2" and 12"). If necessary,
cut and/or bend TUBING carefully. Make sure tube bend is
close to the TEE (1) so that it will not effect the compression
joint at the VALVE CONNECTION.
Remove COUPLING NUT (3) and FERRULE (4) from each
VALVE (2) and slide onto TUBING (5).
NOTE
VALVE inlet is 3/4-inch NPT male.
Certified to comply with ANSI A112.18.1M
M968644 REV.1.4 (10/16)
152-305mm
(6"-8")
70mm
(2-3/4")
52mm
(2")
108mm
(4-1/4")
3'
(76mm)
(C)
(H)
12 MAX.
(305mm)
4
3
1
ADJ. 6-1/2 TO 12
57mm
(2-1/4")
1-1/2 MAX.
(38mm) MAX.
1-3/16 D.
(30mm) D.
5
3
4
MOUNTING
SURFACE
2