Installing The M.2 2280 Solid-State Drive/Intel Optane - Dell Inspiron 7490 P115G Service Manual

Steps
1. Disconnect the battery cable from the system board.
2. Remove the screw (M2x3) that secures the solid-state drive shield to the system board.
NOTE: Solid-state drive shield is available only in computers that are shipped with Intel Optane or solid-state drive
that has a capacity of more than 512 GB.
3. Gently remove the solid-state drive shield off the solid-state drive slot on the system board.
4. Slide and remove the M.2 2280 solid-state drive/Intel Optane off the solid-state drive slot on the system board.

Installing the M.2 2280 solid-state drive/Intel Optane

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: M.2 2280 solid-state drive/Intel Optane is supported in computers shipped with WLAN card only.
About this task
Enable the Intel Optane device after you replace it. For more information about enabling the Intel Optane device, see
memory.
The following image indicates the location of the M.2 2280 solid-state drive/Intel Optane and provides a visual representation of the
installation procedure.
16 Removing and installing components
Enabling Intel Optane