Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Raindrip R675CT
Summary of Contents for Raindrip R675CT
- Page 1 R675CT Installation & Programming Video available on Raindrip.com/timers...
- Page 2 Installation Tool-Free! Tip: Must have minimum of 15 PSI at hose bib. Hose Bib Hand Tighten Timer Visit Raindrip.com/timers...
- Page 3 Programming Tip: “AUTOMATIC” light will flash when in automatic mode. 1. Set Frequency (Frequency = How OFTEN you want the water to come on.) From RESET position, turn dial to desired setting. (Example has timer starting once a day.) Turn dial from RESET position at the time of day watering is to start (e.g.
- Page 4 Getting Started 1. Make sure you have: (2) Alkaline AA batteries • (not included) Batteries Timer 2. Load the batteries as shown: Tip: Firmly push down on the battery tray to ensure it is clicked into the timer. Visit Raindrip.com/timers...
-
Page 5: Manual Watering
Extra Features Tip: Manual light will flash when in Manual or Rain Delay modes. Rain Delay (Rain Delay = Watering delayed for a specified period of time) From RESET position, turn dial to desired “Rain Delay” setting. (The example shows the program will resume in 48 hours.) Manual Watering (Manual Mode = Watering in between... - Page 6 Run Time dial must be 30 minutes or less.) Winterize: remove from faucet, remove batteries and store indoors. Warranty: Limited three year warranty from date of purchase. (original receipt required for warranty claim) 2855 S. East Ave. Fresno, CA 93725 Visit Raindrip.com/timers Technical Service: 888-825-4716...
Need help?
Do you have a question about the R675CT and is the answer not in the manual?
Questions and answers
valve won't open in manual mode
The Raindrip R675CT valve may not open in manual mode due to internal mechanical failure, such as a clicking sound without valve activation. This suggests the timer receives power but the valve mechanism is not functioning correctly.
This answer is automatically generated
I have just returned home and both the manual and automatic feature lights are blinking. It did not water on its normal cycle. I checked the batteries and they are good, reinstalled them and set frequency and time. The automatic light is flashing now an I am waiting to see if it comes on in 4 hours. Have you any idea of why both lights would have blinked, manual cycle feature was set on reset.
On the Raindrip R675CT, the manual and automatic feature lights blink to indicate programming is complete and the timer is in either manual or rain delay mode. The manual light flashes while manual watering is active and during a rain delay. Once the cycle ends, the light turns off.
This answer is automatically generated
when you set the frequency and run time, does the valve turn on for that session?
I bought a R675CT Raindrip irrigation package last year and worked fine. I disconnected the timer in the fall, removed the batteries and stored inside over the winter. Now when I insert new batteries, the Automatic light blinks twice and then nothing. All connections look clean but doesn't work.