Best Wi-Q Technology EXQ Series Installation Instructions Manual

Introduction
These installation instructions describe how to install your
BEST® Wi-Q Technology™ EXQ Series Exit Hardware Trim.
Electronic Stand-Alone Exit Hardware Trim is available for
use with the following types of wide stile exit devices:
Precision® brand manufactured by BEST (2000 Series),
Von Duprin® (98/99 Series), and Sargent® (8800 Series).
Not all features are available for all exit device configura-
tions. The table below details what sensors are available
for which exit device configurations:
n
Device
Precision
Rim (2100)
Surface Vertical (2200)
Mortise (2300)
Wood Door Concealed (2700)
Concealed Vertical (2800)
d
Von Duprin
Rim
Surface Vertical
Concealed Vertical
e
Sargent
f
Rim
a. Door position sensing
b. Request-to-exit (PHI touchbar monitoring)
c. Latch sensing
d. Von Duprin is a registered trademark of Von Duprin, Inc.
e. Sargent is a registered trademark of Sargent Mfg. Co.
f. Latch must have lift-type trim input (8863)
Installation Instructions for
Wi-Q Technology™ EXQ
Exit Hardware Trim
a b c
DS TS LS
■ ■ ■
■ ■ ■
■
■ ■ ■
■ ■ ■
■ ■
■
■
■
BEST
a Product Group of dormakaba USA Inc.
Contents
These instructions cover the following topics:
Planning the installation................................................ 1
Preparing the door.......................................................... 3
Installing the exit hardware and trim ........................... 7
Completing the installation ......................................... 16
Site survey
Use the following survey to record information about the
installation site and hardware application.
Exit hardware type:
❑ rim ❑ surface vertical rod
❑ mortise ❑ concealed vertical rod
Door handing and bevel:
❑ Left-hand reverse bevel (LHRB)
❑ Right-hand reverse bevel (RHRB)
Door type:
❑ Wood ❑ Metal
inches (1-3/4" to 2-1/4" )
Door thickness:
Components checklist
Use the following checklist to make sure that you have the
items necessary to install your EXQ Exit Hardware Trim.
❑ Escutcheon and
lever assembly
1