Badgematic 900 FLEXI Manual page 18

4.
step
Now the upper stamp has to be put into the Flexi-holding. Therefor, the retaining pin in the upper
stamp has to be put into the whole in the bridge which you can see if you take a look at the bridge
from above. Put the retaining pin into the right position until it is exactly in this hole and then push
the upper stamp upwards until you hear a "click". It is best if you push against the Flexi-holding
with your two thumbs at the same time.
18
The retaining pin has to be positioned exactly between the two
split pins.
retaining pin
split pin
Now put the upper stamp below the Flexi-holding, so that the
distance bolt on the swivelling plate is exactly between the two
split pins of the upper stamp.