Advertisement
Available languages
Available languages
FIrst stePs
Put the badge maker on a table in front of you. In the carton you separately find the rubber
handle – screw it into the operating lever.
Open the carton with the stamp set. Put the stamp set into the badge maker as described on page
17 – 19 concerning step 3-5.
Now the machine is ready to start.
making Buttons
1.
step
Before starting, you should have the required button badge parts ready. Normally these parts
include a metal top, a metal backside (depending on the backside variation you want to produce),
a foil and the paper inlay you have designed, printed and cut before. The paper inlay must have
exactly the same diameter as the foil. Therefor you can use our "Print On Me" paper, one of our
circle cutters or you cut the paper inlay by hand (see "Hints and Tricks").
1.
3.
Turn the swivelling plate, so that lower stamp 1 is in front of you. Now put into it one after another:
The metal top, the paper inlay and the foil. Depending on the design on your paper inlay, you
should pay attention to the right position of the design. Otherwise the design will not be in the
right position after you have put the button onto your clothes.
2.
4.
13
Advertisement
