Download Print this page

Installation Information; Surface Mounting - Whirlpool IMPRESS LFB2611L Manual

Hide thumbs

Advertisement

INSTALLATION INFORMATION

1.
Determine desired ironing board height
above the floor (see the Mounting Height
Chart below). NOTE: The ironing station
enclosure will extend approximately 11"
into the room.
NOTE: The user can adjust height of board
after the installation with a 4" differential be-
tween a maximum and minimum height. Fig-
ures under the left column are for the normal
default position.
Desired Board Height
(Inches)
38
37
36
35
3 4
33
32
31
30
29
28
2.
Locate the wall stud that will be used for
mounting the ironing station. The stud
should be located as close to the center of
the cabinet as possible.
3.
Using a 3/16" drill bit, predrill holes in the
upper and lower cabinet cross braces
where the lag screws will be located.
4.
If installed, allow at least 16" to the side of
the cabinet for the door swing.
5.
Using a 3/16" drill bit, predrill a pilot hole in
the wall stud where the cabinet will be
attached to the wall.
6.
Attach the cabinet to the wall by inserting
the lag screws, (included with the ironing
station), through the predrilled holes in the
cabinet cross frames, or braces, and screw
them into the predrilled pilot holes in the
wall stud.
All manuals and user guides at all-guides.com

SURFACE MOUNTING

Mount Cabinet Above Floor
(Inches)
30
29
28
27
26
25
2 4
23
22
21
20
ELECTRICAL CONSIDERATIONS
All electrical work must be done in accordance
with all applicable electrical codes.
WARNING: Turn off the power at the service
entrance before wiring this unit.
Pigtails are provided behind the control panel.
Use the strain relief provided.
Access Hole
1
2-1
3
4

Advertisement

loading

  Also See for Whirlpool IMPRESS LFB2611L