Related Manuals for attika ElectronicAIR
Summary of Contents for attika ElectronicAIR
- Page 1 BRUGERVEJLEDNING BEDIENUNGSANLEITUNG USER MANUAL MANUEL D’UTILISATEUR BRUKERVEILEDNING BRUKSANVISNING KÄYTTÖOHJE GEBRUIKERHANDLEIDING DK - 1...
- Page 2 CONTENTS ElectronicAIR Start-up Inserting batteries in the remote control Synchronisation of the remote control and receiver Setting the remote control Use of wood-burning stove with ElectronicAIR Troubleshooting 16 - GB...
- Page 3 ELECTRONICAIR ElectronicAIR is an electronic system that is programmed to regulate the combustion air in the wood-burning stove. Two thermocouples constantly communicate with the receiver and remote control. Based on this communication, the damper opens or closes automatically to ensure the optimal combustion during the start-up and continuous burning. The LED indicates when the wood-burning stove automatically changes the damper’s position.
- Page 4 INSERTING BATTERIES IN THE REMOTE CONTROL First, insert new batteries in the remote control. The remote control must be in the manual setting for the remote control and the receiver to synchronise. If the remote control is in the automatic setting, set it to manual by briefly pushing the ‘up’ and ‘down’ buttons at the same time. Manual setting Automatic setting Down...
- Page 5 SETTING THE REMOTE CONTROL The remote control can be set to display the time, temperature, etc. To enter the manual setting menu, press the ‘up’ button and ‘down’ button at the same time for about five seconds, until the display changes. •...
- Page 6 Menu 3: Set the time. First select the hours. Menu 4: Next, select the minutes. Menu 5: Activate or de-activate the child lock. Menu 6: Settings for type of fuel: 00 wood or 01 coal. It is very important that this setting is set to 00 (wood). 00 Setting for wood 01 Setting for coal When you have finished with the six settings, you must wait 15 seconds for the settings to be...
- Page 7 If you want the damper on the wood-burning stove to be regulated automatically, you can use the remote control to set the stove to automatic operation. Follow this guide showing how to operate a wood-burning stove with ElectronicAIR that is in automatic operation mode.
- Page 8 TROUBLESHOOTING The table below lists the most frequent causes of why the LED light is lit red or yellow. LED light Cause Solution The LED light flashes yellow twice Warning: Low battery power in the Replace the batteries in the receiver. a minute.
Need help?
Do you have a question about the ElectronicAIR and is the answer not in the manual?
Questions and answers