Biostar M7MKE Supplementary Manual page 74

All manuals and user guides at all-guides.com
Chapter 4
.     "#  ,?'+ "
 ! 0

Connector between hard When attempting to run
drive and system board the FDISK utility you get a
unplugged. message, INVALID
DRIVE SPECIFICATION.
Damaged hard disk or Format hard disk; if
disk controller. unable to do so the hard
disk may be defective.
Hard disk directory or Run the FDISK program,
FAT is scrambled. format the hard drive.
Copy data that was
backed up onto hard
drive.
.   ,?'+9         
      
 ! 0

Hard Disk boot program A number of causes could
has been destroyed. be behind this.
%)*#
 2!  !0* !2
Check cable running from
disk to disk controller
board. Make sure both
ends are securely plugged
in; check the drive type in
the standard CMOS
setup.
Contact technical
support.
Backing up the hard drive
is extremely important. All
hard disks are capable of
breaking down at any
time.
%)*#
 2!  !0* !2
Back up data and
applications files.
Reformat the hard drive.
Re-install applications and
data using backup disks.
,5&
Trouble shooting