System Installation - Rheem NPT 200 Installation Instructions Manual

THIS WATER HEATER IS NOT SUITABLE FOR POOL HEATING.
The system is suitable for installation with NPT 200 solar collectors as part of an
open circuit system installation.
The system is not suitable for installation above 400 metres altitude.
IMPORTANT NOTES

Working on roofs is and should always be considered a hazardous activity,
particularly early in the morning, late in the evening, when the roof is wet and
during and after periods of rain.

All work must be carried out in accordance with Local, State and Federal
Occupational Safety, Health and Welfare Regulations. In particular, the
requirements for safety whilst manual lifting, working at heights and on roofs.

Installers must be competently trained in:
 Height Hazard Assessment
 Working at Height Procedures
 Assessment / Use / Wearing of correct height safety equipment
(harnesses etc.)
 All other relevant safety factors specific to the installation and
maintenance work to be compliant with suitable Occupational, Health and
Safety Regulations / Codes.

All relevant permits shall be obtained from the regulatory authorities before
commencing work to install the solar hot water system.

All work carried out must be performed by appropriately qualified
tradespeople or be suitably supervised for trades assistant duties.

Every care must be taken to protect and warn occupants of the building and
the public from personal injury which may occur from falling tools, roof
materials, fittings or any other hazards of a general nature.

Advise the occupants of any inconvenience which may occur due to
disconnection of existing water and electrical supplies.

The connection, attachment, integration or general association of other
equipment or parts which either directly or indirectly affect the operation or
performance of this equipment could void the warranty.

SYSTEM INSTALLATION

5